Chimney Chase Repair in Wellington, FL

Chimney chase repair is one of the most common jobs we handle in Wellington, because the village's housing stock is dominated by newer prefab fireplace systems where a framed, sided chase replaces the traditional masonry chimney. These chases — typically built with wood framing, a layer of sheathing, and vinyl or stucco siding — look solid from the ground, but they are vulnerable in ways a masonry chimney is not. Wellington's relentless summer humidity and the wind-driven rain from inland thunderstorms find the seams, and once water gets inside the chase cavity, it has nowhere easy to go.

Chimney Chase Repair: What the Work Looks Like

The kind of chimney chase repair work we handle for Wellington homeowners — swipe to see more.

Why Wellington Homes Need Chimney Chase Repair

The failure pattern we see most often in Wellington chases starts at the top. The chase cover — a flat or shallow-sloped metal panel — pools water after every storm. When the cover is undersized or the sealant around its edges has dried out, water wicks down under the cover and into the chase. From there it soaks into the framing around the flue liner, wicks into the OSB sheathing, and can eventually reach the ceiling joists of the living space below. By the time a homeowner notices a stain on the drywall or smells something musty, the framing inside the chase may already be compromised. The siding on the outside often looks fine until you open the chase up.

Our chase repairs in Wellington begin with a methodical diagnosis: we remove the chase cover, look inside with a light and a camera, and probe the framing for soft spots. If the damage is limited to the sheathing and siding, we replace the affected sections, treat any mold, and reinstall with properly lapped and sealed joints before fitting a new sloped chase cover with a drip-edge overhang. If the framing itself has been compromised by prolonged moisture, we replace the structural members before closing the chase back up. We do not patch the surface and leave wet framing behind.

Wellington homeowners in communities with factory-built fireplaces should not assume their chase is fine just because the exterior siding looks clean. Vinyl siding in particular can look perfect on the outside while the wood behind it is quietly rotting. If you have ever seen rust streaks running down the side of your chase, noticed the chase cover sitting unevenly, or picked up a musty odor near the fireplace wall after a storm, those are the signals we take seriously. We give you a straight account of what we find before any work begins.

Signs You Need Chimney Chase Repair

• Rust streaks running down the sides of a metal-topped chimney chase
• Water pooling on top of the chase cover instead of draining off
• Leaks or stains showing up near a prefab (factory-built) fireplace
• Damaged, soft, or rotting siding on the chase structure

How It Works